QSC ISA280 Power Amfi 2X280W/4 Ohm

Stok durumu veya tedarik süresini sorunuz: 0 (533) 592 49 10
Hızlı Gönderi
  • Four models for low-impedance applications
  • ISA 1350 drives 70V lines directly with 1500 watts / channel
  • Three "Ti" versions include low-impedance and isolated 25, 70, and 100 volt outputs for distributed audio systems
  • Rear panel gain controls for tamper resistant operation with 2 dB detents for quick and repeatable settings
  • XLR and detachable Euro style input connectors
  • DataPort V2 for use with DPV2-compatible signal processing accessories (XC-3, SF-3, LF-3) and DSP-3/DSP-4 (with external power supply)
  • Independent defeatable clip limiters for reduced distortion
  • Selectable high-pass filters protect speakers and prevent speaker transformer saturation with minimal effect on program material (30 Hz or 70 Hz on non-"Ti" models, 50 Hz or 75 Hz on "Ti" models)
  • Class H complementary bipolar output circuitry reduces AC power draw and waste heat by 40% on ISA 750 and 800Ti, and by 50% on ISA 1350
  • Front panel indicators include power, signal, and clip (and protect on ISA 1350)
  • Covered barrier strip output connectors for safety agency compliance
  • Automatic variable-speed fan for quiet normal operation with maximum cooling on demand
  • Rear-to-front air flow keeps equipment racks cool
  • Stereo, Bridge, or Parallel operating modes
  • Comprehensive protection circuitry including DC, infrasonic, thermal overload and short circuit protection

 

SPECIFICATIONSISA280ISA450ISA750ISA1350ISA300TiISA500TiISA800Ti
 STEREO MODE, Both Channels Driven
8 ohms 20 Hz-20 kHz 0.1% THD 185W 260W 450W 800W 185W 260W 450W
4 ohms 20 Hz-20 kHz 0.1% THD 280W 425W 650W 1300W 280W 425W 650W
2 ohms 1 kHz 1% THD 430W 700W 1200W 2000W 430W 700W 1200W
 DIRECT POWER, STEREO MODE
70V 20 Hz-20 kHz +0/-0.3 dB 0.5% THD - - - 1500W - - -
 XF OUTPUT POWER, STEREO MODE
70V or 100V 50 Hz-16 kHz 0.5% THD - - - - 300W 500W 800W
25V 50 Hz-16 kHz 0.5% THD - - - - 200W 300W 500W
 BRIDGED MONO MODE
8 ohms 1 kHz 0.1% THD 600W 900W 1500W 2800W 600W 900W 1500W
4 ohms 1 kHz 1% THD 830W 1400W 2400W 4000W 830W 1400W 2400W
 XF OUTPUT POWER, BRIDGED MONO MODE
140V or 200V 50 Hz-16 kHz 0.5% THD - - - - 600W 1000W 1600W
Signal to Noise (20 Hz-20 kHz) 100 dB 100 dB 100 dB 100 dB 100 dB 100 dB 100 dB
Distortion (SMPTE-IM) Less than 0.01% Less than 0.01% Less than 0.02% Less than 0.01% Less than 0.01% Less than 0.01% Less than 0.02%
Input Sensitivity @ 8 ohms 1.15v
(+3.4 dBu)
1.07v
(+2.8 dBu)
1.07v
(+2.8 dBu)
1.24v
(+4.1 dBu)
1.15v
(+3.4 dBu)
1.07v
(+2.8 dBu)
1.07v
(+2.8 dBu)
Voltage Gain @ 8 ohms
 
33.4x
(30.5 dB)
44.7x
(33 dB)
56.2x
(35 dB)
64.0x
(36.1 dB)
33.4x
(30.5 dB)
44.7x
(33 dB)
56.2x
(35 dB)
Output Circuitry Class AB Class AB Class H Class H, 3 Tier Class AB Class AB Class H
THX Approved -THX ApprovedTHX Approved - - - -
Weight - Net
 
36 lbs
(16.3 kg)
42 lbs
(19 kg)
47 lbs
(21.3 kg)
68 lbs
(30.8 kg)
44 lbs
(20.0 kg)
49 lbs
(22.3 kg)
57 lbs
(26 kg)
Weight - Shipping
 
42 lbs
(19.1 kg)
48 lbs
(22 kg)
53 lbs
(24.0 kg)
77 lbs
(34.4 kg)
50 lbs
(22.7 kg)
55 lbs
(25 kg)
63 lbs
(28.6 kg)
 ALL MODELS
Distortion (Typical)
20 Hz-20 kHz: 10 dB below rated power
1.0 kHz and below: full rated power
Less than 0.03% THD, 4 ohms and 8 ohms

Less than 0.03% THD, 4 ohms and 8 ohms
Frequency Response
10 dB below rated output power
 
ISA 280, 450, 750 and 1350:
20 Hz-20 kHz, +0/-1 dB; -3 dB points: 5 Hz and 50 kHz
ISA 300Ti, 500Ti and 800Ti:
Direct outputs: -3 dB @ 50 Hz, -0.5 dB @ 20 kHz; XF outputs: 50 Hz-16 kHz, +1/-3 dB
Damping Factor (direct outputs) Greater than 200 at 8 ohms, ISA 1350 greater than 250
Output Regulation (isolated outputs) Less than 1.5 dB
Input Impedance 10 k ohms unbalanced, 20 k ohms balanced
Input Clipping 10 Vrms (+22 dBu)
Cooling Continuously variable speed fan, back-to-front air flow
Connectors, each channel Input: Active balanced; 3-pin Euro-style detachable terminal block and XLR (pin 2+)
Output: Covered barrier strips
DataPort V2: HD-15 connector
Controls Front: AC switch
Rear: Ch. 1 and Ch. 2 gain knobs, 10-position DIP switch
Indicators PWR-ON: Green LED; SIGNAL: Green LED (1 per channel);
CLIP: Red LED (1 per channel)
Dimensions 19" (48.3 cm) rack mounting, 5.25"(13.3cm) tall (3 rack spaces),
15.9" (40 cm) deep (from front mounting rails)
Amplifier Protection Full short circuit, open circuit, thermal, ultrasonic, and RF protection;
Stable into reactive or mismatched loads
Power Requirements 120, 230, VAC, 50-60 Hz
Load Protection On/off muting; Triac crowbar: ISA 750, 1350 and 800Ti; AC coupling: ISA 280, 300Ti, 450 and 500Ti

 

Tamamlayıcı vs Benzer Ürünler
{x} kişi bu ürünü inceliyor.
Yükleniyor...